Huawei Quidway S3900 Series User Manual

Operation Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 802.1x Configuration
Huawei Technologies Proprietary
1-18
Table 1-5 Enable DHCP-triggered authentication
Operation Command Description
Enter system view
system-view
—
Enable
DHCP-triggered
authentication
dot1x dhcp-launch
Optional
By default, DHCP-triggered
authentication is disabled.
1.5.5 Configuring Guest VLAN
Table 1-6 Configure Guest VLAN
Operation Command Description
Enter system view
system-view
—
Configure port
access method
dot1x port-method
{ macbased | portbased }
Optional
The default port access
method is
MAC-address-based. That is,
the macbased keyword is
used by default.
Enable the Guest
VLAN function
dot1x guest-vlan vlan-id
[ interface interface-list ]
Required
By default, the Guest VLAN
function is disabled.
Caution:
z The Guest VLAN function is available only when the switch operates in a port-based
authentication mode.
z Only one Guest VLAN can be configured for each switch.
1.6 Displaying and Debugging 802.1x
After performing the above configurations, you can display and verify the
802.1x-related configuration by executing the display command in any view.
You can clear 802.1x-related statistics information by executing the reset command in
user view.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English