Operation Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 8 MSDP Configuration
Huawei Technologies Proprietary
8-9
Operation Description Related section
Configure MSDP peer
connection control
Optional
Section
8.3.5 Configuring
MSDP Peer Connection
Control
8.3.2 Configuring Description Information for MSDP Peers
You can configure description information for each MSDP peer to manage and
memorize the MSDP peers.
Table 8-3 Configure description information for an MSDP peer
Operation Command Description
Enter system view
system-view
—
Enter MSDP view
msdp
—
Configure description
information for an MSDP
peer
peer peer-address
description text
Optional
The peer-address
argument is the address
of the peer. You can
configure addresses of
multiple peers for multiple
times.
By default, an MSDP peer
has no description text.
8.3.3 Configuring Anycast RP Application
If you configure the same interface (usually Loopback interface) addresses on two RPs
in the same PIM-SM domain, the two RPs will be MSDP peers to each other. To prevent
failure of RPF check on SA messages between MSDP peers, you must configure the
RP address to be carried in the SA messages.
Table 8-4 Configure Anycast RP application
Operation Command Description
Enter system view
system-view
—
Enter MSDP view
msdp
—
Create an MSDP peer
connection
peer peer-address
connect-interface
interface-type
interface-number
Required
To Next Page
Loading...
