Huawei Quidway S3900 Series - Displaying and Maintaining Ospf Configuration

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 4 OSPF Configuration
Huawei Technologies Proprietary
4-26
Operation Command Description
Enable OSPF Trap
snmp-agent trap enable
ospf [ process-id ]
[ ifauthfail | ifcfgerror |
ifrxbadpkt |
ifstatechange |
iftxretransmit |
lsdbapproachoverflow |
lsdboverflow |
maxagelsa |
nbrstatechange |
originatelsa | vifauthfail |
vifcfgerror |
virifrxbadpkt |
virifstatechange |
viriftxretransmit |
virnbrstatechange ]*
Optional
You can configure OSPF
to send diversified SNMP
TRAP messages and
specify a certain OSPF
process to send SNMP
TRAP messages by
process ID.
4.8 Displaying and Maintaining OSPF Configuration
After the above configuration, you can use the display command in any view to
display and verify the OSPF configuration.
You can use the reset command in user view to reset the OSPF counter or
connection.
Table 4-22 Display configuration
Operation Command Description
Display brief information
about one or all OSPF
processes
display ospf
[ process-id ] brief
Display OSPF statistics
display ospf
[ process-id ] cumulative
Display OSPF LSDB
information
display ospf
[ process-id ] [ area-id ]
lsdb [ brief | [ asbr | ase
| network | nssa | router
| summary
[ ip-address ] ]
[ originate-router
ip-address |
self-originate ] ]
Display OSPF peer
information
display ospf
[ process-id ] peer [ brief
| statistics ]
Display OSPF next hop
information
display ospf
[ process-id ] nexthop
You can execute the
display command in any
view.