Operation Manual - DLDP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 DLDP Configuration
Huawei Technologies Proprietary
1-10
II. Network diagram
SwitchB
SwitchA
PC
GE2/1/3
GE2/1/3
GE2/1/4
GE2/1/4
SwitchB
SwitchA
PC
GE2/1/3
GE2/1/3
GE2/1/4
GE2/1/4
SwitchB
SwitchA
PC
GE2/1/3
GE2/1/3
GE2/1/4
GE2/1/4
SwitchB
SwitchA
PC
GE2/1/3
GE2/1/3
GE2/1/4
GE2/1/4
Figure 1-3 Fiber cross-connection
III. Configuration procedure
1) Configure Switch A
# Configure the ports to work in mandatory full duplex mode at the speed of 1000 Mbps.
<QuidwayA> system-view
[QuidwayA] interface gigabitethernet 2/1/3
[QuidwayA-GigabitEthernet2/1/3] duplex full
[QuidwayA-GigabitEthernet2/1/3] speed 1000
[QuidwayA-GigabitEthernet2/1/3] quit
[QuidwayA] interface gigabitethernet 2/1/4
[QuidwayA-GigabitEthernet2/1/4] duplex full
[QuidwayA-GigabitEthernet2/1/4] speed 1000
[QuidwayA-GigabitEthernet2/1/4] quit
# Enable DLDP globally
[QuidwayA] dldp enable
# Set the interval of sending DLDP packets to 15 seconds
[QuidwayA] dldp interval 15
# Configure DLDP to work in enhanced mode
[QuidwayA] dldp work-mode enhance
# Set the DLDP handling mode for unidirectional links to auto
[QuidwayA] dldp unidirectional-shutdown auto
# Display the DLDP status
[QuidwayA] display dldp 2
To Next Page
Loading...
