Operation Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 MSTP Configuration
Huawei Technologies Proprietary
1-8
Operation Remarks Related section
Maximum hops of
MST region
configuration
Optional
Section 1.2.7 “MST
Region Maximum Hops
Configuration”
Network diameter
configuration
Optional
The default is recommended.
Section
1.2.8 “Network
Diameter Configuration”
MSTP time-related
configuration
Optional
The defaults are recommended.
Section
1.2.9 “MSTP
Time-related
Configuration”
Timeout time factor
configuration
Optional
Section 1.2.10 “Timeout
Time Factor Configuration”
Maximum
transmitting speed
configuration
Optional
The default is recommended.
Section
1.2.11 “Maximum
Transmitting Speed
Configuration”
Edge port
configuration
Optional
Section 1.2.12 “Edge Port
Configuration”
Point-to-point link
related
configuration
Optional
Section 1.2.13
Point-to-point Link-Related
Configuration”
Note:
In a network that contains switches with both GVRP and MSTP employed, GVRP
packets are forwarded along the CIST. If you want to broadcast packets of a specific
VLAN through GVRP, be sure to map the VLAN to the CIST when configuring the
MSTP VLAN mapping table (The CIST of a network is the spanning tree instance
numbered 0.)
1.2.1 Prerequisites
The status of the switches in the spanning trees are determined. That is, the status
(root, branch, or leaf) of each switch in each spanning tree instance is determined.
1.2.2 MST Region Configuration
I. Configuration procedure
Table 1-3 Configure an MST region
Operation Command Description
Enter system view
system-view
—
Enter MST region view
stp region-configuration
—
To Next Page
Loading...
