Operation Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 MSTP Configuration
Huawei Technologies Proprietary
1-20
I. Configuration procedure (in system view)
Table 1-13 Configure the maximum transmitting speed for specified ports in system
view
Operation Command Description
Enter system view
system-view
—
Configure the maximum
transmitting speed for
specified ports
stp interface interface-list
transmit-limit packetnum
Required
The maximum transmitting
speed of all Ethernet ports
on a switch defaults to 10.
II. Configuration procedure (in Ethernet port view)
Table 1-14 Configure the maximum transmitting speed in Ethernet port view
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Configure the maximum
transmitting speed
stp transmit-limit
packetnum
Required
The maximum transmitting
speed of all Ethernet ports
on a switch defaults to 10.
As the maximum transmitting speed parameter determines the number of the
configuration BPDUs transmitted in each Hello time, set it to a proper value to avoid
MSTP from occupying too many network resources. The default is recommended.
III. Configuration example
# Set the maximum transmitting speed of Ethernet1/0/1 port to 15.
z Configure the maximum transmitting speed in system view.
<Quidway> system-view
[Quidway] stp interface ethernet1/0/1 transmit-limit 15
z Configure the maximum transmitting speed in Ethernet port view.
<Quidway> system-view
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp transmit-limit 15
1.2.12 Edge Port Configuration
Edge ports are ports that neither directly connects to other switches nor indirectly
connects to other switches through network segments. After a port is configured as an
To Next Page
Loading...
