Huawei Quidway S3900 Series - Page 256

Operation Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 MSTP Configuration
Huawei Technologies Proprietary
1-22
[Quidway] stp interface ethernet1/0/1 edged-port enable
z Configure in Ethernet port view.
<Quidway> system-view
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp edged-port enable
1.2.13 Point-to-point Link-Related Configuration
A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can transit to the
forwarding state rapidly by exchanging synchronization packets, eliminating the
forwarding delay.
You can specify whether or not the link connected to a port is a point-to-point link in one
of the following two ways.
I. Configuration procedure (in system view)
Table 1-17 Specify whether or not the links connected to the specified ports are
point-to-point links (in system view)
Operation Command Description
Enter system view
system-view
—
Specify whether or not
the links connected to
the specified ports are
point-to-point links
stp interface interface-list
point-to-point { force-true
| force-false | auto }
Required
The auto keyword is
adopted by default.
The force-true keyword
specifies that the links
connected to the specified
ports are point-to-point
links.
The force-false keyword
specifies that the links
connected to the specified
ports are not point-to-point
links.
The auto keyword specifies
to automatically determine
whether or not the links
connected to the specified
ports are point-to-point
links.