Huawei Quidway S3900 Series User Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 RIP Configuration
Huawei Technologies Proprietary
3-12
Simple authentication cannot provide complete security, because the authentication
keys sent along with packets are not unencrypted. Therefore, simple authentication
cannot be applied where high security is required.
Table 3-15 Set RIP-2 packet authentication mode
Operation Command Description
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Set RIP-2 packet
authentication mode
rip authentication-mode
{ simple password | md5
{ rfc2453 key-string | rfc2082
key-string key-id } }
Required
If you specify to use
MD5 authentication, you
must specify one of the
following MD5
authentication types:
rfc2453 (this type
supports the packet
format defined in RFC
2453)
rfc2082 (this type
supports the packet
format defined in RFC
2082)
V. Configuring a RIP neighbor
Table 3-16 Configure a RIP neighbor
Operation Command Description
Enter system view
system-view
—
Enter RIP view
rip
—
Configure a RIP
neighbor
peer ip-address
Required
To make RIP works on a
link that does not support
broadcast/multicast
packets, you must
manually configure the
RIP neighbor.
Normally, RIP uses
broadcast or multicast
addresses to send
packets.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English