Operation Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 5 Logging in through Web-based
Network Management System
Huawei Technologies Proprietary
5-3
[Quidway-Vlan-interface1] ip address 10.153.17.82 255.255.255.0
2) Configure the user name and the password for the Web-based network
management system.
z Add a WEB user account for the switch, setting the user level to level 3 (the
administration level).
# Configure the user name to be admin.
[Quidway] local-user admin
# Set the user level to level 3.
[Quidway-luser-admin] service-type telnet level 3
# Set the password to admin.
[Quidway-luser-admin] password simple admin
z Configure a static route from the switch to the gateway, assuming that the IP
address of the gateway is 192.168.0.50.
[Quidway] ip route-static ip-address 0.0.0.0 255.255.255.255 192.168.0.50
3) Establish an HTTP connection between your PC and the switch, as shown in the
following figure.
PC
HTTP Connection
Sw itc h
PC
HTTP Connection
PC
HTTP Connection
Sw itc h
PC
HTTP connection
PC
HTTP Connection
Sw itc h
PC
HTTP Connection
PC
HTTP Connection
Sw itc h
PC
HTTP connection
Figure 5-3 Establish an HTTP connection between your PC and the switch
4) Log into the switch through IE. Launch IE on the Web-based network
management terminal (your PC) and enter the IP address of the management
VLAN interface of the switch (here it is
http://10.153.17.82) in the address bar.
(Make sure the route between the Web-based network management terminal and
the switch is available.)
To Next Page
Loading...
