Operation Manual – FTP and TFTP
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 FTP and TFTP Configuration
Huawei Technologies Proprietary
1-7
II. Network diagram
Switch
PC
Network
Network
Switch
PC
Network
Network
Figure 1-2 Network diagram for FTP configurations
III. Configuration procedure
1) Configure the switch
# Log into the switch. (You can log into a switch through the Console port or by
Telneting to the switch. See the “Login” module for detailed information.)
<Quidway>
# Start the FTP service on the switch and create a user account and the corresponding
password.
<Quidway> system-view
[Quidway] ftp server enable
[Quidway] local-user switch
[Quidway-luser-switch] password simple hello
[Quidway-luser-switch] service-type ftp
2) Run an FTP client application on the PC to connect to the FTP server. Upload the
application named switch.bin to the root directory of the Flash memory of the FTP
server, and download the configuration file named vrpcfg.cfg from the FTP server.
The following takes the command line window tool provided by Windows as an
example:
# Enter the command line window and switch to the directory where the file switch.bin is
located. In this example it is in the root directory of C:\.
C:\>
# Access the Ethernet switch through FTP. Input the user name “switch” and password
“hello” to log in and enter FTP view.
C:\> ftp 1.1.1.1
Connected to 1.1.1.1.
220 FTP service ready.
User (1.1.1.1:(none)): switch
331 Password required for switch.
Password:
To Next Page
Loading...
