Huawei Quidway S3900 Series - Page 874

Operation Manual – FTP and TFTP
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 FTP and TFTP Configuration
Huawei Technologies Proprietary
1-16
Operation Command Description
Set the TFTP file
transmission mode
tftp { ascii | binary }
Optional
By default, the binary file
transmission mode is adopted.
Specify the ACL
adopted when a
switch attempts to
connect a TFTP
server
tftp-server acl acl-number
Optional
III. Specifying the source interface and source IP address for a TFTP client
You can specify the source interface and source IP address for a switch acting as a
TFTP client, so that it connects with a remote TFTP server through the IP address of
the specified interface or the specified IP address.
Table 1-11 Specify the source interface and source IP address for a TFTP client
Operation Command Description
Specify the source
interface so that the TFTP
client uses it to connect
with a TFTP server for the
next time
tftp tftp-server
source-interface
interface-type
interface-number { get
source-file [ dest-file ] | put
source-file-url [ dest-file ] }
Optional
Specify the source IP
address so that the TFTP
client uses it to connect
with a TFTP server for the
next time
tftp tftp-server source-ip
ip-address { get source-file
[ dest-file ] | put source-file-url
[ dest-file ] }
Optional
Enter system view
system-view
—
Specify the source
interface so that the TFTP
client always uses it to
connect with a TFTP
server
tftp source-interface
interface-type
interface-number
Optional
Specify the source IP
address so that the TFTP
client always uses it to
connect with a TFTP
server
tftp source-ip ip-address
Optional
Display the source IP
address that the TFTP
client always uses it to
connect with a TFTP
server
display tftp source-ip
This command can be
executed in any view.