Operation Manual – System Maintenance and Debugging
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 2 Basic System Configuration &
Debugging
Huawei Technologies Proprietary
2-5
z Terminal display, which controls whether the debugging information is output to a
user screen.
The relation between the two switches is as follows:
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Terminal display switches
1
3
Debugging information
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Terminal display switches
1
3
Debugging information
Figure 2-1 Debugging information output
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Table 2-11 Enable debugging and terminal display
Operation Command Description
Enable system
debugging
debugging module-name
[ debugging-option ]
By default, all debugging is
disabled in the system.
Because the output of
debugging information will
affect the efficiency of the
system, disable your
debugging after you finish it.
Enable terminal
display for
debugging
terminal debugging
By default, terminal display
for debugging is disabled.