Huawei Quidway S5600 Series - Page 116

Operation Manual – VLAN
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2 VLAN Configuration
Huawei Technologies Proprietary
2-6
II. Configuration procedure
Table 2-6 Associate a port with the protocol-based VLAN
Operation Command Description
Enter system view
system-view
—
Enter port view
interface interface-type
interface-number
Required
Associate a port
with the
protocol-based
VLAN
port hybrid protocol-vlan
vlan vlan-id { protocol-index
[ to protocol-end ] | all }
Required
Caution:
For the operation of adding a port to the VLAN in the untag way, refer to the section
“Port Basic Configuration” in this manual.
2.3.3 Displaying Protocol-Based VLAN Configuration
After the configuration above, you can execute the display command in any view to
display the running status, so as to verify the configuration.
Table 2-7 Display VLAN configuration
Operation Command Description
Display the
information about
the protocol-based
VLAN
display vlan [ vlan-id [ to vlan-id ] |
all | static | dynamic ]
Display the protocol
information and
protocol indexes
configured on the
specified VLAN
display protocol-vlan vlan
{ vlan-id [ to vlan-id ] | all }
Display the protocol
information and
protocol indexes
configured on the
specified port
display protocol-vlan interface
{ interface-type interface-number
[ to interface-type
interface-number ] | all }
You cam execute the
display command in
any view