Huawei Quidway S5600 Series - Displaying the Device Management Configuration; Updating the Bootrom; Updating the Host Software in the Fabric

Operation Manual – System Maintenance and Debugging
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 4
Device Management
Huawei Technologies Proprietary
4-3
Table 4-4 Specify the APP to be adopted at reboot
Operation Command Description
Specify the APP to
be adopted at
reboot
boot boot-loader
[ backup-attribute ] { file-url
[ fabric ] | device-name }
Optional
4.2.5 Updating the BootROM
You can use the BootROM application saved in the Flash memory of the switch to
update the running BootROM application. With this command, a remote user can
conveniently update the BootRom by uploading the BootROM to the switch through
FTP and running this command. The BootROM can be used when the switch reboots.
Perform the following configuration in user view:
Table 4-5 Update the BootROM
Operation Command Description
Update the
BootROM
boot bootrom { file-url |
device-name }
Optional
4.2.6 Updating the Host Software in the Fabric
You can execute the following commands on any device and use a specified host
software to upload all devices in a Fabric, thus to even the software versions in this
Fabric.
Table 4-6 Update the host software in the Fabric
Operation Command Description
Update the host software
on the devices in the
Fabric
update fabric { file-url |
device-name }
Optional
4.3 Displaying the Device Management Configuration
After the above configurations, you can execute the display command in any view to
display the operating status of the device management to verify the configuration
effects.