Operation Manual – ACL
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
ACL Configuration
Huawei Technologies Proprietary
1-4
Operation Command Description
Create a time
range
time-range time-name
{ start-time to end-time
days-of-the-week [ from
start-time start-date ] [ to
end-time end-date ] | from
start-time start-date [ to
end-time end-date ] | to
end-time end-date }
Required
Display a time
range or all the
time ranges
display time-range { all |
time-name }
Optional
This command can be
executed in any view.
If only a periodic time section is defined in a time range, the time range is active only
within the defined periodic time section.
If only an absolute time section is defined in a time, the time range is active only within
the defined absolute time section.
If both a periodic time section and an absolute time section are defined in a time range,
the time range is active only when the periodic time range and the absolute time range
are both matched. Assume that a time range defines an absolute time section from
00:00 January 1, 2004 to 23:59 December 31, 2004, and a periodic time section from
12:00 to 14:00 every Wednesday. This time range is active only from 12:00 to 14:00
every Wednesday in 2004.
If the start time is specified, the time range starts on the current date and ends on the
end date.
If the end date is note specified, the time range is from the date of configuration till the
largest date available in the system.
1.2.2 Configuration Example
# Define a time range that will be active from 8:00 to 18:00 Monday through Friday.
<Quidway> system-view
[Quidway] time-range test 8:00 to 18:00 working-day
[Quidway] display time-range test
Current time is 13:27:32 4/16/2005 Saturday
Time-range : test ( Inactive )
08:00 to 18:00 working-day
1.3 Defining Basic ACLs
A basic ACL defines rules only based on the L3 source IP addresses to analyze and
process data packets.
To Next Page
Loading...
Need help?
General