Huawei Quidway S5600 Series User Manual

Operation Manual – IP Address and Performance Confiugration
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 1
IP Address Configuration
Huawei Technologies Proprietary
1-5
Operation Command Description
Enter VLAN interface
view
interface Vlan-interface
vlan-id
—
Configure an IP
address for a VLAN
interface
ip address ip-address { mask
| mask-length } [ sub ]
Required
By default, a VLAN
interface has no IP
address.
After an IP address is
assigned to the VLAN
interface through
BOOTP or DHCP, you
cannot configure a
secondary IP address
for the VLAN
interface.
1.4 Displaying IP Address Configuration
After the above configuration, you can execute the display command in any view
to display the operating status and configuration on the interface to verify your
configuration.
Table 1-3 Display IP address configuration
Operation Command Description
View VLAN
interface
information
display ip interface
[ brief [ interface-type
[ interface-number ] ] |
[ interface-type
interface-number ] ]
You can execute the display
command in any view.
1.5 IP Address Configuration Example
I. Network requirements
Set the IP address and subnet mask of VLAN interface 1 to 129.2.2.1 and
255.255.255.0 respectively.
II. Network diagram
Console cable
Sw itc h
PC
Console cable
Sw itc h
PC
Figure 1-3 IP address configuration

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English