Huawei Quidway S5600 Series User Manual

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration
Huawei Technologies Proprietary
1-12
Operation Command Description
Configure the
specified key to be
a trusted key
ntp-service reliable
authentication-keyid key-id
Required
By default, an authentication
key is not a trusted key
Enter VLAN
interface view
interface vlan-interface
vlan-id
—
Broadcast server mode:
ntp-service
broadcast-server
authentication-keyid key-id
Associate a
specified key with
the corresponding
NTP server
Multicast server mode:
ntp-service
multicast-server
authentication-keyid key-id
z In NTP broadcast server
mode and NTP multicast
server mode, you need to
associate the specified key
with the corresponding
NTP server on the server
z You can associate an NTP
server with an
authentication key while
configuring a switch to
operate in a specific NTP
mode. You can also
associate them using this
command after configuring
the NTP mode where a
switch is to operate
 Note:
The procedures for configuring NTP authentication on the server are the same as that
on the client. Besides, the client and the server must be configured with the same
authentication key.
1.5 Configuration of Optional NTP Parameters
Optional NTP parameters are:
z The local VLAN interface that sends NTP packets
z The number of the dynamic sessions that can be established locally
z Disabling the VLAN interface configured on a switch from receiving NTP packets
Table 1-6 Configure optional NTP parameters
Operation Command Description
Enter system view
system-view
—
Configure the local
interface that
sends NTP
packets
ntp-service
source-interface
interface-type
interface-number
Optional

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English