Huawei Quidway S5600 Series - VLAN-VPN Configuration; Configuration Prerequisites; Configuration Procedure

Operation Manual – VLAN VPN
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
VLAN-VPN Configuration
Huawei Technologies Proprietary
1-2
packet. Otherwise, the packet becomes a packet carrying the default VLAN tag of the
port.
1.2 VLAN-VPN Configuration
1.2.1 Configuration Prerequisites
z GARP VLAN registration protocol (GVRP), GARP multicast registration protocol
(GMRP), neighbor topology discovery protocol (NTDP), spanning tree protocol
(STP) , 802.1x protocol,and Centralized MAC address authentication are disabled
on the port.
z The port is must an access port.
Caution:
z If any of the protocols among GVRP, GMRP, NTDP, STP, 802.1x, and Centralized
MAC address authentication is enabled for a port, you can not enable the
VLAN-VPN function for the port.
z By default, STP and NTDP are enabled on a device. You can disable these two
protocols using the stp disable and undo ntdp enable commands.
1.2.2 Configuration procedure
Table 1-1 Configure the VLAN-VPN function for a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the
VLAN-VPN
function on the port
vlan-vpn enable
Required
By default, the VLAN-VPN
function is disabled on a port.
Display VLAN VPN
configuration
information about
all ports
display port vlan-vpn
You can execute the display
command in any view.