Huawei Quidway S5600 Series User Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 3 RIP Configuration
Huawei Technologies Proprietary
3-3
Configuration Task Description
Referenc
e section
Setting the additional
routing metrics of an
interface
Optional
3.4.2 I.
Configuring RIP route
summary
Optional
3.4.2 II.
Disabling the receiving of
host routes
Optional
3.4.2 III.
Configuring RIP to filter or
advertise the received
routes
Optional
3.4.2 IV.
Setting RIP preference Optional 3.4.2 V.
Enabling RIP traffic
sharing
Optional
3.4.2 VI.
Configuring RIP Route
Control
Configuring RIP to import
routes from another
protocol
Optional
3.4.2 VII.
Configuring RIP timers Optional 3.5.2 I.
Configuring split horizon Optional 3.5.2 II.
Configuring RIP-1 packet
zero field check
Optional
3.5.2 III.
Setting RIP-2 packet
authentication mode
Optional
3.5.2 IV.
RIP Network
Adjustment and
Optimization
Configuring a RIP neighbor Optional
3.5.2 V.
Displaying and Maintaining RIP Configuration Optional 0
3.3 Basic RIP Configuration
3.3.1 Configuration Prerequisites
Before configuring basic RIP functions, perform the following tasks:
z Configuring the link layer protocol
z Configuring the network layer addresses of interfaces so that adjacent nodes are
reachable to each other at the network layer

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English