Operation Manual – Information Center
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
Huawei Technologies Proprietary
1-14
 Note:
z To view debug information of specific modules, you need to set the information type
as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
z To send information to remote SNMP workstation properly, related configurations
are required on both the switch and the SNMP workstation.
1.3 Displaying and Debugging Information Center
Configuration
After the above configurations, you can execute the display command in any view to
display the running status of the information center, and thus validate you
configurations. You can also execute the reset command in user view to clear the
information in the log buffer and trap buffer.
Table 1-13 Display and debug information center
Operation Command
Descriptio
n
Display information on
information channel
display channel [ channel-number |
channel-name ]
Display the operation status
of information center, the
configuration of information
channels, the format of time
stamp and the information
output in case of fabric
display info-center [ unit unit-id ]
Display the status of log
buffer and the information
recorded in log buffer
display logbuffer [ unit unit-id ] [ level
severity | size buffersize ]* [ | { begin |
exclude | include }
regular-expression ]
Display the summary
information recorded in log
buffer
display logbuffer summary [ level
severity ]
Display the status of trap
buffer and the information
recorded in trap buffer
display trapbuffer [ unit unit-id ] [ size
buffersize ]
The
display
command
can be
executed in
any view
Clear information recorded
in log buffer
reset logbuffer [ unit unit-id ]
Clear information recorded
in trap buffer
reset trapbuffer [ unit unit-id ]
The reset
command
can be
executed in
user view
To Next Page
Loading...
Need help?
General