Huawei Quidway S5600 Series User Manual

Operation Manual – Information Center
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
Huawei Technologies Proprietary
1-7
 Note:
Running the info-center synchronous command during debugging information
collection may result in a command prompt echoed after each item of debugging
information. To avoid unnecessary output, it is recommended that you disable
synchronous terminal output in such cases.
1.2.2 Enabling Information Output to a Log Host
Table 1-5 lists the related configurations on the switch.
Table 1-5 Enable information output to a log host
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output for a
specified switch in
a fabric
info-center switch-on
{ unit unit-id | master | all }
[ debugging | logging |
trapping ]*
By default, debugging
information output is enabled ,
and log and trap information
output are disabled for the
master switch in a fabric.
Debugging, log and trap
information output are all
disabled for other switches in
the fabric.
Enable information
output to a log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number | language
{ chinese | english } ]*
Required
By default, the switch does
not output information to the
log host.
After you configure the switch
to output information to the log
host, the switch uses
information channel 2 by
default.
Be sure to set the correct IP
address. A loopback IP
address will cause an error
message prompting invalid
address.
Configure the
source interface
through which log
information is sent
to the log host
info-center loghost source
interface-type
interface-number
Optional

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English