Huawei Quidway S5600 Series User Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2 Static Route Configuration
Huawei Technologies Proprietary
2-3
2.3 Displaying the Routing Table
After the above configuration, use the display command in any view to display and
verify the static route configuration.
Table 2-2 Display the routing table
Operation Command Description
Display routing table summary
display ip
routing-table
Display routing table details
display ip
routing-table
verbose
Display the detailed information
of a specific route
display ip
routing-table
ip-address [ mask ]
[ longer-match ]
[ verbose ]
Display the routes in a specified
address range
display ip
routing-table
ip-address1 mask1
ip-address2 mask2
[ verbose ]
Display the routes discovered by
a specified protocol
display ip
routing-table
protocol protocol
[ inactive | verbose ]
Display the tree-structured
routing table information
display ip
routing-table radix
Display the statistics of the
routing table
display ip
routing-table
statistics
You can execute the
display command in
any view.
2.4 Static Route Configuration Example
I. Network requirements
As shown in Figure 2-1, the masks of all the IP addresses in the figure are
255.255.255.0. It is required that all the hosts/Layer 3 switches in the figure can
interconnect with each other by configuring static routes.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English