Huawei Quidway S5600 Series User Manual

Operation Manual – Port Basic Configuration
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Port Basic Configuration
Huawei Technologies Proprietary
1-11
 Note:
z Optical port (including Combo optical port) does not support VCT
(virtual-cable-test) function.
z Combo electrical port supports VCT function only when it is in UP condition (using
undo shutdown command), normal Ethernet electrical port always supports this
function.
1.2.11 Configuring the Interval to Perform Statistical Analysis on Port Traffic
By performing the following configuration, you can set the interval to perform statistical
analysis on the traffic of a port.
When you use the display interface interface-type interface-number command to
display the information of a port, the system performs statistical analysis on the traffic
flow passing through the port during the specified interval and displays the average
rates in the interval. For example, if you set this interval to 100 seconds, the displayed
information is as follows:
Last 100 seconds input: 0 packets/sec 0 bytes/sec
Last 100 seconds output: 0 packets/sec 0 bytes/sec
Table 1-14 Set the interval to perform statistical analysis on port traffic
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set the interval to perform
statistical analysis on port
traffic
flow-interval interval
Optional
By default, this
interval is 300
seconds.
1.2.12 Enabling Giant-Frame Statistics Function
The giant-frame statistics function is used to ensure transmission of network traffic and
to facilitate statistics and analysis of unusual traffic on the network.
Table 1-15 Enable the giant-frame statistics function
Operation Command Description
Enter system view
system-view
—

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English