Huawei Quidway S5600 Series - Management Device Configuration

Operation Manual – Cluster
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Cluste
r
Huawei Technologies Proprietary
1-7
1.2 Management Device Configuration
1.2.1 Management Device Configuration Tasks
Table 1-2 Management device configuration tasks
Operation Description Related section
Enable NDP
globally and for
specific ports
Required
Section
1.2.2 Enabling NDP
Globally and for Specific Ports
Configure
NDP-related
parameters
Required
Section
1.2.3 Configuring
NDP-related Parameters
Enable NTDP
globally and for
specific ports
Required
Section
1.2.4 Enabling NTDP
Globally and for Specific Ports
Configure
NTDP-related
parameters
Required
Section
1.2.5 Configuring
NTDP-related Parameters
Enable the cluster
function
Required
Section 1.2.6 Enabling the
Cluster Function
Configure cluster
parameters
Required
Section 1.2.7 Configuring
Cluster Parameters
Configure
interaction for the
cluster
Required
Section
1.2.8 Configuring
Interaction for the Cluster
Configure NM
interface for the
cluster
Optional
Section
1.2.9 Configuring NM
Interface for the Cluster
1.2.2 Enabling NDP Globally and for Specific Ports
Table 1-3 Enable NDP globally and for a specific port
Operation Command Description
Enter system view
system-view
—
Enable NDP globally
ndp enable
Required
By default, NDP is enabled
globally
Enable
NDP for
In system
view
ndp enable interface
port-list
You must choose one of
them