Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches Chapter 1 QoS Configuration
Huawei Technologies Proprietary
1-8
z Dynamic aggregation supported by queue scheduling modes on ports
If the queue scheduling configuration information of some LACP-enabled up ports is
the same, these ports can be aggregated into the same aggregation group.
z Static aggregation or manual aggregation supported by queue scheduling modes
on ports
You can add a queue-scheduling-enabled port into a specific static or manual
aggregation group. This operation can be performed not only on the local device but
also cross devices in intelligent resilient framework (IRF).
z You can use the copy command to copy the queue scheduling configuration of a
port.
Note:
For the introduction to the copy command, refer to the Basic Port Configuration Module
in this manual.
1.1.10 Redirect
You can re-specify the forwarding port of packets as required by your own QoS policy.
1.1.11 Queue Scheduling
When the network is congested, the problem that many packets compete for resources
must be solved, usually in the way of queue scheduling.
In the following section, strict priority (SP) queuing, and weighted round robin (WRR)
queuing are introduced.
1) SP queuing
To Next Page
Loading...
