Huawei Quidway S5600 Series User Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 3 RIP Configuration
Huawei Technologies Proprietary
3-9
Operation Command Description
Enable traffic sharing
traffic-share-across-interface
Optional
VII. Configuring RIP to import routes from another protocol
Table 3-11 Configure RIP to import routes from another protocol
Operation Command Description
Enter system view
system-view
—
Enter RIP view
rip
—
Set the default cost for
RIP to import routes
from other protocols
default cost value
Optional
When you use the
import-route
command without
specifying the cost of
imported routes, the
default cost you set
here will be used.
Configure RIP to
import routes from
another protocol
import-route protocol
[ process-id ][ cost value |
allow-ibgp | route-policy
route-policy-name ]*
Optional
The allow-ibgp
parameter is used only
for importing BGP
routes.
The process-id
parameter is used only
for importing OSPF
routes.
3.5 RIP Network Adjustment and Optimization
In some special network environments, some RIP features need to be configured and
RIP network performance needs to be adjusted and optimized. By performing the
configuration mentioned in this section, the following can be implemented:
z Changing the convergence speed of RIP network by adjusting RIP timers,
z Avoiding routing loop by configuring split horizon,
z Traffic sharing based on multiple equivalent routes,
z Packet validation in network environments with high security requirements, and
z Configuring RIP feature on an interface or link with special requirements.
3.5.1 Configuration Prerequisites
Before adjusting RIP, perform the following tasks:

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English