Huawei Quidway S5600 Series User Manual

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration
Huawei Technologies Proprietary
1-6
NTP implementation mode Configuration on S5600 switches
Broadcast mode
z Configure the S5600 switch to operate in
NTP broadcast server mode. In this case,
the S5600 switch broadcast NTP packets
through the VLAN interface configured on
the switch.
z Configure the S5600 switch to operate in
NTP broadcast client mode. In this case,
the S5600 switch receives broadcast NTP
packets through the VLAN interface
configured on the switch.
Multicast mode
z Configure the S5600 to operate in NTP
multicast server mode. In this case, the
S5600 switch sends multicast NTP
packets through the VLAN interface
configure on the switch.
z Configure the S5600 switch to operate in
NTP multicast client mode. In this case,
the S5600 switch receives multicast NTP
packets through the VLAN interface
configure on the switch.
1.2 NTP Implementation Mode Configuration
A switch can operate in the following NTP modes:
z NTP client mode
z NTP server mode
z NTP peer mode
z NTP broadcast server mode
z NTP broadcast client mode
z NTP multicast server mode
z NTP multicast client mode
1.2.1 Prerequisites
When an S5600 switch operates in NTP server mode or NTP peer mode, you need to
perform configuration on the client or the active peer only. When an S5600 switch
operates in NTP broadcast mode or NTP multicast mode, you need to perform
configurations on both the server side and the client side.
1.2.2 Configuring NTP Implementation Modes
Table 1-2 Configure NTP implementation modes
Operation Command Description
Enter system view
system-view
—

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English