Huawei Quidway S5600 Series - Creating an Isp Domain

Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
Huawei Technologies Proprietary
1-14
1.3.1 Configuration Prerequisites
If you want to adopt remote AAA method, you must create a RADIUS or HWTACACS
scheme.
z RADIUS scheme (radius-scheme): You can reference a configured RADIUS
scheme to implement AAA services. For the configuration of RADIUS scheme,
refer to section
1.4 "RADIUS Configuration".
z HWTACACS scheme (hwtacacs-scheme): You can reference a configured
RADIUS scheme to implement AAA services. For the configuration of RADIUS
scheme, refer to section
1.5 "HWTACACS Configuration".
1.3.2 Creating an ISP Domain
Table 1-5 Create an ISP domain
Operation Command Description
Enter system view
system-view
—
Create an ISP domain and enter
its view, enter the view of an
existing ISP domain, or
configure the default ISP
domain
domain { isp-name |
default { disable | enable
isp-name } }
Required
The default ISP
domain is
"system".
1.3.3 Configuring the Attributes of an ISP Domain
Table 1-6 Configure the attributes of an ISP domain
Operation Command Description
Enter system view
system-view
—
Create an ISP domain or
enter the view of an existing
ISP domain
domain isp-name
Required
Activate/deactivate the ISP
domain
state { active | block }
Optional
By default, once an
ISP domain is
created, it is in the
active state and all
the users in this
domain are allowed
to access the
network.