Operation Manual – System Maintenance and Debugging
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
BootROM and Host Software Loading
Huawei Technologies Proprietary
1-17
Upgrading Bootrom, please wait...
Upgrade Bootrom succeeded!
<Quidway> reboot
When rebooting the switch, use the file s5600.btm as BootROM to finish BootROM
loading.
2) Loading host software
Loading the host software is the same as loading the BootROM program, except for
that the file to be downloaded is the host software file, and that you need to use the
boot boot-loader command to select the host software at reboot of the switch.
Note:
z The steps listed above are performed in the Windows operating system, if you use
other FTP client software, refer to the corresponding user’s guide before operation.
z Only the configurations steps concerning loading are illustrated here, for detailed
description on the corresponding configuration commands, refer to the chapter
“FTP and TFTP”.
1.3.2 Remote Loading Using TFTP
The remote loading using TFTP is similar to that using FTP. The only difference is that
TFTP is used instead off FTP to load software to the switch, and the switch can only act
as a TFTP client.
To Next Page
Loading...
Need help?
General