Huawei Quidway S5600 Series - Configuring Priority Remark

Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches Chapter 1 QoS Configuration
Huawei Technologies Proprietary
1-13
Operation Command Description
Set the port priority
priority priority-level
Optional
By default, the port priority is 0
Table 1-7 Set to use the packet priority
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Set the switch to use
the packet priority
priority trust
Through this
configuration, the switch
uses the packet priority
instead of the port priority
III. Configuration example
z Set to use the port priority and specify the priority of GigabitEthernet1/0/1 to 7.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface gigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] undo priority-trust cos
[Quidway-GigabitEthernet1/0/1] priority 7
z Set the switch to use the 802.1p priority carried in the packet on
GigabitEthernet1/0/1.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] priority trust
1.5 Configuring Priority Remark
Refer to 1.1.5 Priority Remark for the introduction to priority remark.
Priority remark can be implemented in the following ways:
z Through TP. When configuring TP, you can define the action of remarking the
DSCP priority of the packets out of the traffic limit. Refer to
1.8.2 Configuration
Procedure of TP.