Operation Manual - QoS&QoS Profile
Quidway S5600 Series Ethernet Switches Chapter 1 QoS Configuration
Huawei Technologies Proprietary
1-14
z Through the traffic-priority command. Then you can remark the IP precedence,
802.1p priority, DSCP priority and local precedence.
1.5.1 Configuration Prerequisites
z ACL rules used for traffic identifying are defined. Refer to the ACL module in the
book for defining ACL rules
z The type and value of the precedence that the packets matching with ACL rules
are remarked are determined
z The ports which need this configuration are defined
1.5.2 Configuration Procedure
Table 1-8 Configure priority remark
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Use ACL rules in
traffic identifying and
specify a new
precedence for the
packet matching with
the ACL rules
traffic-priority inbound
acl-rule { { dscp dscp-value
| ip-precedence { pre-value
| from-cos } } | cos
{ pre-value | from-ipprec } |
local-precedence
pre-value }*
Required
Display the parameter
configurations of
priority remark
display qos-interface
{ interface-type
interface-number | unit-id }
traffic-priority
Display all the QoS
settings of the port
display qos-interface
{ interface-type
interface-number | unit-id }
all
Optional
You can execute the
display command in any
view
acl-rule: Applied ACL rules which can be the combination of various ACL rules. The
way of combination is described in the following table:
Table 1-9 Ways of issuing combined ACLs
ACL combination Form of the acl-rule argument
Apply all the rules in an IP ACL
separately
ip-group acl-number
Apply a rule in an IP ACL separately
ip-group acl-number rule rule
Apply all the rules in a Link ACL
separately
link-group acl-number