Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration
Huawei Technologies Proprietary
1-14
1.7 Configuration Example
1.7.1 NTP Server Mode Configuration
I. Network requirements
Configure the local clock of Quidway1 to be NTP master clock, with the stratum being
2.
 Note:
Quidway1 is a switch that allows the local clock to be the master clock.
An S5600 series switch operates in client mode, with Quidway1 as the time server.
Quidway1 operates in server mode automatically.
II. Network diagram
Quidway 1
1.0.1.11/24
1.0.1.12/24
Quidway 1
1.0.1.11/24
S5600
1.0.1.12/24
Quidway 1
1.0.1.11/24
1.0.1.12/24
Quidway 1
1.0.1.11/24
S5600
1.0.1.12/24
n
Figure 1-6 Network diagram for the NTP server mode configuratio
III. Configuration procedures
The following configurations are for the S5600 switch.
# View the NTP status of the S5600 switch before synchronization.
<S5600> display ntp-service status
Clock status: unsynchronized
Clock stratum: 16
Reference clock ID: none
Nominal frequence: 99.8562 Hz
Actual frequence: 99.8562 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 0.00 ms
Root dispersion: 0.00 ms
Peer dispersion: 0.00 ms
Reference time: 00:00:00.000 UTC Jan 1 1900 (00000000.00000000)
# Configure Quidway1 to be the time server.
<S5600> system-view
[S5600] ntp-service unicast-server 1.0.1.11
To Next Page
Loading...
Need help?
General