Huawei Quidway S5600 Series User Manual

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration
Huawei Technologies Proprietary
1-22
1.7.5 NTP Server Mode with Authentication Configuration
I. Network requirements
The local clock of Quidway1 operates as the master NTP clock, with the clock stratum
set to 2.
An S5600 series switch operates in client mode with Quidway1 as the time server.
Quidway1 operates in the server mode automatically. Meanwhile, NTP authentication
is enabled on both sides.
 Note:
This example assumes that Quidway1 is a switch that supports the local clock being
the master NTP clock.
II. Network diagram
Quidway 1
1.0.1.11/24
1.0.1.12/24
Quidway 1
1.0.1.11/24
S5600
1.0.1.12/24
Quidway 1
1.0.1.11/24
1.0.1.12/24
Quidway 1
1.0.1.11/24
S5600
1.0.1.12/24
Figure 1-10 Network diagram for NTP server mode with authentication configuration
III. Configuration procedures
1) Configure the S5600 series switch.
# Enter system view.
<S5600 > system-view
[S5600]
# Configure Quidway1 to be the time server.
[S5600] ntp-service unicast-server 1.0.1.11
# Enable NTP authentication.
[S5600] ntp-service authentication enable
# Set the MD5 key to 42, with the content being aNiceKey.
[S5600] ntp-service authentication-keyid 42 authentication-mode md5 aNiceKey
# Specify the key to be a trusted key.
[S5600] ntp-service reliable authentication-keyid 42
[[S5600] ntp-service unicast-server 1.0.1.11 authentication-keyid 42

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English