Huawei Quidway S5600 Series - Page 307

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 3 RIP Configuration
Huawei Technologies Proprietary
3-8
Operation Command Description
filter-policy gateway
ip-prefix-name import
The gateway keyword
is used to filter the
incoming routes
advertised from a
specified address.
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [ routing-protocol ]
Configure RIP to filter
outgoing routes
filter-policy route-policy
route-policy-name export
Required
By default, RIP does
not filter any outgoing
routes.
 Note:
z The filter-policy import command filters the RIP routes received from neighbors,
and the routes being filtered out will neither be added to the routing table nor be
advertised to any neighbors.
z The filter-policy export command filters all the routes to be advertised, including
the routes imported by using the import-route command as well as RIP routes
learned from neighbors.
z The filter-policy export command without the routing-protocol argument filters all
the routes to be advertised, including the routes imported by the import-route
command.
V. Setting RIP preference
Table 3-9 Set RIP preference
Operation Command Description
Enter system view
system-view
—
Enter RIP view
rip
—
Set the RIP preference
preference value
Optional
The default RIP preference is 100.
VI. Enabling RIP traffic sharing
Table 3-10 Enable RIP traffic sharing
Operation Command Description
Enter system view
system-view
—
Enter RIP view
rip
—