Huawei Quidway S5600 Series User Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 3 RIP Configuration
Huawei Technologies Proprietary
3-4
3.3.2 Configuring Basic RIP Functions
I. Enabling RIP globally and on the interface of a specified network segment
Table 3-2 Enable RIP globally and on the interface of a specified network segment
Operation Command Description
Enter system view
system-view
—
Enable RIP globally and
enter RIP view
rip
—
Enable RIP on the
interface of a specified
network segment
network
network-address
Required
By default, RIP is disabled
on any interface.
 Note:
z RIP can be enabled on an interface only after it has been enabled globally.
z RIP operates on the interface of a network segment only when it is enabled on the
interface. When RIP is disabled on an interface, it does not operate on the interface,
that is, it neither receives/sends routes on the interface nor forwards its interface
route. Therefore, after RIP is enabled globally, you must also specify its operating
network segments to enable it on the corresponding interfaces.
z The network 0.0.0.0 command is used to enable RIP on all interfaces.
II. Setting the RIP operating status on an interface
Table 3-3 Setting the RIP operating status on an interface
Operation Command Description
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Enable the interface to
receive RIP update
packets
rip input
Enable the interface to
send RIP update
packets
rip output
Run RIP on the
interface
rip work
Optional
By default, except for
loopback interface, all
interfaces are allowed
to send and receive
RIP packets.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English