Huawei Quidway S5600 Series User Manual

Operation Manual – IP Address and Performance Confiugration
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 2
IP Performance Configuration
Huawei Technologies Proprietary
2-2
Operation Command Description
Configure timeout time for
the synwait timer in TCP
tcp timer syn-timeout
time-value
Optional
By default, the
value of the
TCP synwait
timer is 75
seconds.
Configure timeout time for
the finwait timer in TCP
tcp timer fin-timeout
time-value
Optional
By default, the
value of the
TCP finwait
timer is 675
seconds.
Configure the socket
receive/send buffer size of
TCP
tcp window window-size
Optional
By default, the
size of the
transmission
and receiving
buffers is 8 KB.
2.1.4 Configuring Direct-Connected Broadcast Packet Receiving and
Forwarding
Broadcast packets include full-net broadcast packets and direct-connected
broadcast packets. A direct-connected broadcast packet is a packet whose
destination IP address is the network broadcast address of a subnet, but source IP
address is not in the subnet segment.
You can use the following commands to set whether to receive or forward
direct-connected broadcast packets.
Table 2-2 Configure direct-connected broadcast packet receiving and forwarding
Operation Command Description
Enter system view
system-view
-
Enable
direct-connected
broadcast packet
receipt
ip forward-broadcast
Optional
By default, the system
prohibits direct-connected
broadcast packet receipt
Enter VLAN
interface view
interface
Vlan-interface vlan-id
-
Enable
direct-connected
broadcast packet
forwarding through
interface
ip forward-broadcast
[ acl-number ]
Optional
By default, the system
prohibits direct-connected
broadcast packet forwarding
through interface

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English