Huawei Quidway S5600 Series User Manual

Operation Manual – IP Address and Performance Confiugration
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 2
IP Performance Configuration
Huawei Technologies Proprietary
2-4
Table 2-4 Debug IP performance
Configuration Command Description
Clear IP traffic statistics
reset ip statistics
Clear TCP traffic
statistics
reset tcp statistics
Clear UDP traffic
statistics
reset udp statistics
Execute this
command in user
view.
2.3 Troubleshooting
Symptom: IP packets are forwarded normally, but TCP and UDP cannot work
normally.
Solution: Enable the corresponding debugging information output to view the
debugging information.
z Use the display command to display the IP performance and check whether
the PC runs normally.
z Use the terminal debugging command to enable debugging information to
be output to the console.
z Use the debugging udp packet command to enable the UDP debugging to
trace UDP packets.
<Quidway> terminal debugging
<Quidway> debugging udp packet
The UDP packets are shown in the following format:
UDP output packet:
Source IP address:202.38.160.1
Source port:1024
Destination IP Address 202.38.160.1
Destination port: 4296
z Use the debugging tcp packet command to enable the TCP debugging to
trace TCP packets.
<Quidway> terminal debugging
<Quidway> debugging tcp packet
Then the TCP packets received or sent will be displayed in the following format in
real time:
TCP output packet:
Source IP address:202.38.160.1
Source port:1024
Destination IP Address 202.38.160.1
Destination port: 4296
Sequence number :4185089

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English