Huawei Quidway S5600 Series User Manual

Operation Manual – GVRP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
GVRP Configuration
Huawei Technologies Proprietary
1-5
Operation Command Description
Exit and return to
system view
quit
—
Enable GVRP
globally
gvrp
Required
By default, GVRP is disabled
globally.
Enter Ethernet
port view
interface interface-type
interface-number
—
Enable GVRP on
the port
gvrp
Required
By default, GVRP is disabled on
the port.
After you enable GVRP on a
trunk port, you cannot change
the port to a different type.
Configure GVRP
port registration
mode
gvrp registration { fixed |
forbidden | normal }
Optional
You can choose one of the
three modes.
By default, GVRP port
registration mode is normal.
The timeout ranges of the timers vary depending on the timeout values you set for other
timers. If you want to set the timeout time of a timer to a value out of the current range,
you can set the timeout time of the associated timer to another value to change the
timeout range of this timer.
The following table describes the relations between the timers:
Table 1-3 Relations between the timers
Timer Lower threshold Upper threshold
Hold 10 centiseconds
This upper threshold is less than or
equal to one-half of the timeout time
of the Join timer. You can change the
threshold by changing the timeout
time of the Join timer.
Join
This lower threshold is
greater than or equal to twice
the timeout time of the Hold
timer. You can change the
threshold by changing the
timeout time of the Hold
timer.
This upper threshold is less than
one-half of the timeout time of the
Leave timer. You can change the
threshold by changing the timeout
time of the Leave timer.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English