Huawei Quidway S5600 Series - Page 187

Operation Manual – Link Aggregation
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
Link Aggregation Configuration
Huawei Technologies Proprietary
1-13
[Quidway-GigabitEthernet1/0/1] port link-aggregation group 1
[Quidway-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[Quidway-GigabitEthernet1/0/2] port link-aggregation group 1
[Quidway-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[Quidway-GigabitEthernet1/0/3] port link-aggregation group 1
3) Adopting dynamic LACP aggregation mode
# Enable LACP on GigabitEthernet1/0/1 through GigabitEthernet1/0/3.
<Quidway> system-view
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] lacp enable
[Quidway-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[Quidway-GigabitEthernet1/0/2] lacp enable
[Quidway-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[Quidway-GigabitEthernet1/0/3] lacp enable
Note that, the three LACP-enabled ports can be aggregated into a dynamic
aggregation group to implement load sharing only when they have the same basic
configuration (such as rate and duplex mode).