Operation Manual – Auto Detect
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
Auto Detect Implementation
Huawei Technologies Proprietary
2-4
z itch B and Switch C fails, Switch D becomes
p group 1 automatically and the link from Switch D to Switch
link, is enabled.
II. Network diagram
z Packets sourced from Switch A and destined for Switch C is forwarded by Switch
B under normal situations.
When the connection between Sw
the Master in backu
C, the secondary
192.168.1.2
20 .1.1.2
1 0.1.1.3
10.1 .1.4
Switch C
1 92.168.1. 1/24
192.168.1.2/24
19 2.168.1.3 /24
20 .1.1.3/24
1 0.1.1.3/24
Ethernet 1/0/1
Switch A
Switch B
Switch C
Switch D
VLAN 1
VLAN 1
VLAN 1
VLAN 1
10.1 .1.4/24
20.1.1.4 /24
192.168.1.2
20 .1.1.2
1 0.1.1.3
10.1 .1.4
Switch C
1 92.168.1. 1/24
192.168.1.2/24
19 2.168.1.3 /24
20 .1.1.3/24
1 0.1.1.3/24
Switch A
Switch B
Switch C
Switch D
VLAN 1
VLAN 1
VLAN 1
VLAN 1
GE1/0/1
GE1/0/2
10.1 .1.4/24
20.1.1.4 /24
r implementing the auto detect function in VRRP
III. Configuration procedure
etect-group 9
ting the detect
ip address 10.1.1.4
yB-Vlan-interface1] ip address 192.168.1.2 24
the backup
2.168.1.10
to decrease the priority
i e1] vrrp vrid 1 priority 110
rack detect-group 9 reduced 20
Figure 2-2 Network diagram fo
z Configure Switch B.
# Create detecting group 9.
<QuidwayB> system-view
[QuidwayB] d
# Specify to detect the reachability of the IP address 10.1.1.4/24, set
number to 1.
[QuidwayB-detect-group-9] detect-list 1
[QuidwayB-detect-group-9] quit
# Assign an IP address to VLAN 1 interface.
[QuidwayB] interface vlan-interface 1
[Quidwa
# Enable VRRP on VLAN 1 interface and assign a virtual IP address to
group.
[QuidwayB-Vlan-interface1] vrrp vrid 1 virtual-ip 19
# Set the backup group priority of switch B to 110, and specify
by 20 when the result of detecting group 9 is unreachable.
[Qu dwayB-Vlan-interfac
[QuidwayB-Vlan-interface1] vrrp vrid 1 t
To Next Page
Loading...
Need help?
General