Huawei Quidway S5600 Series - Page 245

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
MSTP Configuration
Huawei Technologies Proprietary
1-9
Operation Command Description
Enter MST region
view
stp region-configuration
—
Configure a name
for the MST region
region-name name
Required
The default MST region name
of a switch is its MAC
address.
instance instance-id vlan
vlan-list
Configure the
VALN mapping
table for the MST
region
vlan-mapping modulo
modulo
Required
Both commands can be used
to configure VLAN mapping
tables.
By default, all VLANs in an
MST region are mapped to
spanning tree instance 0.
Configure the
MSTP revision
level for the MST
region
revision-level level
Required
The default revision level of
an MST region is level 0.
Activate the
configuration of the
MST region
manually
active
region-configuration
Required
Display the
configuration of the
current MST region
check
region-configuration
Optional
Display the
currently valid
configuration of the
MST region
display stp
region-configuration
You can execute this
command in any view.
Configuring MST region-related parameters (especially the VLAN mapping table)
results in spanning trees being regenerated. To reduce network topology jitter caused
by the configuration, MSTP does not regenerate spanning trees immediately after the
configuration; it does this only after you perform one of the following operations, and
then the configuration can really takes effect:
z Activating the new MST region-related settings by using the active
region-configuration command
z Enabling MSTP by using the stp enable command
 Note:
Switches belong to the same MST region only when they have the same MST region
name, VLAN mapping table, and MSTP revision level.