Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2 IGMP Snooping Configuration
Huawei Technologies Proprietary
2-15
Device Description
Switch B Layer 2 switch
VLAN 2 contains GigabitEthernet1/0/1 and VLAN 3
contains GigabitEthernet1/0/2. The two ports are
connected to PC1 and PC2 respectively.
GigabitEthernet1/0/10 is connected to Switch A.
PC 1 User 1
PC1 is connected to the GigabitEthernet1/0/1 port
on Switch B.
PC 2 User 2
PC2 is connected to the GigabitEthernet1/0/2 port
on Switch B.
Configure a multicast VLAN, so that the users in VLAN 2 and VLAN 3 can receive
multicast streams through the multicast VLAN.
II. Network diagram
Figure 2-4 Network diagram for multicast VLAN configuration
III. Configuration procedure
The following configuration is based on the prerequisite that the devices are properly
connected and all the required IP addresses are already configured.
1) Configure Switch A:
# Set the interface IP address of VLAN 20 to 168.10.1.1 and enable the PIM DM
protocol on the VLAN interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] vlan 20
[SwitchA-vlan20] interface Vlan-interface 20
To Next Page
Loading...
