Huawei Quidway S5600 Series User Manual

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 6 IGMP Configuration
Huawei Technologies Proprietary
6-10
II. Limit the range of multicast groups that the interface serves
The Layer 3 switch determines the membership of the network segment through
translating the received IGMP join packets. You can configure a filter for each interface
to limit the range of multicast groups that the interface serves.
Table 6-4 Configure IGMP multicast groups on the interface
Operation Command Description
Enter system view system-view —
Enter VLAN interface
view
interface Vlan-interface
interface-number
—
Enable IGMP on the
current interface
igmp enable
Required
IGMP is disabled on the
interface by default.
Configure limit on the
number of joined IGMP
groups on the interface
igmp group-limit limit
Required
By default, the number of
multicast groups passing
a port is not limited.
Limit the range of
multicast groups that the
interface serves
igmp group-policy
acl-number [ 1 | 2 | port
interface-type
interface-number [ to
interface-type
interface-number ] ]
Optional
z By default, the filter is
not configured, that is,
any multicast group is
permitted on a port.
z If the port keyword is
specified, the specified
port must belong to the
VLAN of the VLAN
interface.
z You can configure to
filter the IP addresses
of some multicast
groups in ACL.
z 1 and 2 are the IGMP
version numbers.
IGMPv2 is used by
default.
Quit interface view.
quit
-
Enter Ethernet port view
interface interface-type
interface-number
-

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English