Huawei Quidway S5600 Series - Page 456

Operation Manual – Multicast Protocol
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 6 IGMP Configuration
Huawei Technologies Proprietary
6-12
Operation Command Description
Enter VLAN interface
view
interface Vlan-interface
interface-number
—
Enable IGMP on the
current interface
igmp enable
Required
IGMP is disabled on the
interface by default.
Configure router ports to
join a multicast group
igmp host-join
group-address port
interface-list
Optional
By default, the router port
does not join in any
multicast group.
Quit VLAN interface view.
quit
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure router ports to
join a multicast group
igmp host-join
group-address vlan
vlan-id
Optional
By default, the router port
does not join in any
multicast group.
6.2.5 Configuring IGMP Proxy
I. Configure IGMP Proxy
You can configure IGMP proxy to reduce the workload of configuration and
management of leaf networks without affecting the multicast connections of the leaf
network.
After the configuration of IGMP Proxy on the Layer 3 switch of the leaf network, the leaf
Layer 3 switch is just a host for the external network. Only when the Layer 3 switch has
directly connected members, can it receive the multicast data of corresponding groups.
Table 6-6 Configure IGMP Proxy
Operation Command Description
Enter system view
system-view
—
Enable the multicast
routing protocol
multicast routing-enable
Required
Enter VLAN interface
(which is connected to the
external network) view
interface Vlan-interface
interface-number
—
Enable the IGMP protocol
igmp enable
Required
Configure IGMP Proxy
igmp proxy Vlan-interface
interface-number
Required