Huawei Quidway S5600 Series User Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
Huawei Technologies Proprietary
1-36
Operation Command Description
Set the IP address and
port number of the
primary TACACS
authorization server
primary authorization
ip-address [ port ]
Required
By default, the IP
address of the primary
authorization server is
0.0.0.0, and the port
number is 0.
Set the IP address and
port number of the
secondary TACACS
authorization server
secondary authorization
ip-address [ port ]
Required
By default, the IP
address of the
secondary
authorization server is
0.0.0.0, and the port
number is 0.
Caution:
z The primary and secondary authorization servers cannot use the same IP address.
Otherwise, the system will prompt unsuccessful configuration.
z You can remove a server only when it is not used by any active TCP connection for
sending authorization packets.
1.5.4 Configuring HWTACACS Accounting Servers
Table 1-27 Configure HWTACACS accounting servers
Operation Command Description
Enter system view
system-view
—
Create a HWTACACS
scheme and enter its
view
hwtacacs scheme
hwtacacs-scheme-name
Required
By default, no
HWTACACS scheme
exists.
Set the IP address and
port number of the
primary TACACS
accounting server
primary accounting
ip-address [ port ]
Required
By default, the IP
address of the primary
accounting server is
0.0.0.0, and the port
number is 0.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English