Huawei Quidway S5600 Series User Manual

Operation Manual – Login
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 3 Logging in through Telnet
Huawei Technologies Proprietary
3-5
Table 3-5 Determine the command level when users logging into switches are not
authenticated
Scenario
Authentication
mode
User type Command
Command
level
The user privilege level
level command is not
executed
Level 0
None
(authenticatio
n-mode none)
VTY users
The user privilege level
level command is already
executed
Determined
by the level
argument
3.2.2 Configuration Example
I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
Do not authenticate users logging into VTY 0.
Commands of level 2 are available to users logging into VTY 0.
Telnet protocol is supported.
The screen can contain up to 30 lines.
The history command buffer can contain up to 20 commands.
The timeout time of VTY 0 is 6 minutes.
II. Network diagram
Console port
Console cable
RS-232
Console port
Console cable
RS-232
Figure 3-1 Network diagram for Telnet configuration (with the authentication mode
being none)
III. Configuration procedure
# Enter system view.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English