Huawei Quidway S5600 Series User Manual

Operation Manual – Login
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 3 Logging in through Telnet
Huawei Technologies Proprietary
3-13
Scenario
Authenticati
on mode
User type Command
Command
level
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
The user privilege level level
command is not executed, and
the service-type command does
not specify the available
command level.
Level 0
The user privilege level level
command is not executed, and
the service-type command
specifies the available command
level.
Determined
by the
service-typ
e command
The user privilege level level
command is executed, and the
service-type command does not
specify the available command
level.
Level 0
VTY users that
are
authenticated
in the
password
mode of SSH
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
Determined
by the
service-typ
e command
 Note:
Refer to the corresponding modules in this manual for information about AAA, RADIUS,
and SSH.
3.4.2 Configuration Example
I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
z Configure the name of the local user to be “guest”.
z Set the authentication password of the local user to 123456 (in plain text).
z Set the service type of VTY users to Telnet.
z Configure to authenticate users logging into VTY 0 in scheme mode.
z The commands of level 2 are available to users logging into VTY 0.
z Only Telnet protocol is supported in VTY 0.

Huawei Quidway S5600 Series Specifications

General

Brand	Huawei
Model	Quidway S5600 Series
Category	Switch
Language	English