Operation Manual – FTP and TFTP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1 FTP and TFTP Configuration
Huawei Technologies Proprietary
1-18
[Quidway-vlan-interface1] ip address 1.1.1.1 255.255.255.0
[Quidway-vlan-interface1] quit
# Download the switch application named switch.bin from the TFTP server to the
switch.
<Quidway> tftp 1.1.1.2 get switch.bin switch.bin
# Upload the switch configuration file named vrpcfg.cfg to the TFTP server.
<Quidway> tftp 1.1.1.2 put vrpcfg.cfg vrpcfg.cfg
# Use the boot boot-loader command to specify the downloaded file (switch.bin) to
be the startup file used when the switch starts the next time, and restart the switch.
Thus the switch application is upgraded.
<Quidway> boot boot-loader switch.bin
<Quidway> reboot
Note:
For information about the boot boot-loader command and how to specify the startup
file for a switch, refer to the “System Maintenance and Debugging” module of this
manual.
To Next Page
Loading...
