Huawei Quidway S5600 Series - Page 971

Operation Manual – VLAN VPN
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
VLAN-VPN Configuration
Huawei Technologies Proprietary
1-5
# Set the TPID value of GigabitEthernet1/0/2 port of Switch A to 0x9100, and add the
port to VLAN 10.
<SwitchA> system-view
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] interface GigabitEthernet1/0/2
[SwitchA-GigabitEthernet1/0/2] vlan-vpn tpid 9100
[SwitchA-GigabitEthernet1/0/2] port link-type trunk
[SwitchA-GigabitEthernet1/0/2] port trunk permit vlan 10
# Configure GigabitEthernet1/0/1 port of Switch A to be a VLAN-VPN port and add it to
VLAN 10.
[SwitchA] interface GigabitEthernet1/0/1
[SwitchA-GigabitEthernet1/0/1] port access vlan 10
[SwitchA-GigabitEthernet1/0/1] vlan-vpn enable
[SwitchA-GigabitEthernet1/0/1] quit
2) Configure Switch B
As Switch B is from other manufacturer, here come only configuration requirements: set
ports GigabitEthernet3/1/1 and GigabitEthernet3/1/2 of Switch B to Trunk ports, both of
which belong to VLAN 10.
<SwitchB> system-view
[SwitchB] vlan 10
[SwitchB-vlan10] quit
[SwitchB] interface GigabitEthernet 3/1/1
[SwitchB-GigabitEthernet3/1/1] port link-type trunk
[SwitchB-GigabitEthernet3/1/1] port trunk permit vlan 10
[SwitchB-GigabitEthernet3/1/1] quit
[SwitchB] interface GigabitEthernet 3/1/2
[SwitchB-GigabitEthernet3/1/2] port link-type trunk
[SwitchB-GigabitEthernet3/1/2] port trunk permit vlan 10