Huawei Quidway S5600 Series - Page 981

Operation Manual - HWPing
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 1
HWPing Configurations
Huawei Technologies Proprietary
1-4
# Set the number of test packets sent in a test to 10.
[Quidway-hwping-administrator-icmp] count 10
# Set the timeout time of test operations to 5.
[Quidway-hwping-administrator-icmp] timeout 5
# Enable the test operation.
[Quidway-hwping-administrator-icmp] test-enable
# Display the test results.
[Quidway-hwping-administrator-icmp] display hwping results administrator
icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address: 1.1.1.99
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 2/5/2
Square-Sum of Round Trip Time: 66
Last complete test time: 2004-4-2 7:59:54.7
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[Quidway-hwping-administrator-icmp] display hwping history administrator
icmp
HWPing entry(admin administrator, tag icmp) history record:
Index Response Status LasrRC Time
1 1 1 0 2004-11-25 16:28:55.0
2 1 1 0 2004-11-25 16:28:55.0
3 1 1 0 2004-11-25 16:28:55.0
4 1 1 0 2004-11-25 16:28:55.0
5 1 1 0 2004-11-25 16:28:55.0
6 2 1 0 2004-11-25 16:28:55.0
7 1 1 0 2004-11-25 16:28:55.0
8 1 1 0 2004-11-25 16:28:55.0
9 1 1 0 2004-11-25 16:28:55.9
10 1 1 0 2004-11-25 16:28:55.9
Refer to the HWPing Command Manual for more displaying information.